Taurus II.2a

DISCONTINUED MARCH 10TH  2010

 

Taurus II.2  Specifications

• 16 1/2" x 10 1/2" work surface
• 5 1/2" throat depth 1 1/8" throat height
• 1/5 horse power motor.

 

 

  

 

Taurus 2 Accessory Kit

This kit is equipped with helpful tools for completing any project from cutting straight lines to perfect circles and precise angles. This kit can be purchased from your local stained glass supplier.

Powered by 3 AA batteries (not included). Attaches to the back of your saw with velcro (included). Great for adding light and removing shadow from the work area.

This tool gives the ability to cut straight lines, which would ordinarily be very difficult with your ring saw. Fits anywhere on the saw's work surface.

This item works on any location of the work surface and helps to create perfect circles.

These fit inside the hole of the work surface to keep small pieces of material from falling into the saw and jamming the rotating assembly which could lead to rapid wear, failure and even blade breakage. Note: These hole reducers only work for the Taurus II models.

Works in unison with the straight edge to cut a 30 or 60 degree angle.

Works in unison with the straight edge to cut a 45 degree angle.

This works in unison with the straight edge to make perfect 45 degree beveled edges.

Use the lamp wedge to put a 30 degree bevel on the edge of a finished piece. This will allow the pieces to fit together more tightly, allowing for a smaller, stronger solder joint.

This piece attaches to the front of the saw and keeps flying debris and water away from your eyes.

Titan XT

Hot Glass and Glass Tile Saw

» The Titan cuts straight lines up to 12 inches long every time. It accomplishes this by way of a carriage tray that moves forwards and backwards while it stays perfectly aligned with the rigid ring blade. Makes trimming a cinch.

» The Titan comes with a Megablade that is very fast cutting and leaves an extremely smooth edge.

» Titans can expose a full 3 inches of blade. This makes it perfect for cutting not only pattern bars, glass tile, millifiori, stained glass, glass tubes, rods, streamers, etc. but also cuts bottles, vases and other tall and hollow pieces.

» Fantastic for hard to cut three dimensional blown glass. The Titan can also be used to cut curves both forward and backward in stained glass, wall tile, and glass tile.

» Included with the Titan are triangles for cutting 45/90/30/60 degree angles.

» Titans will fit on any table with a footprint of 12 by 18 inches.

» The Titan is a Wet Table Saw with a Smooth Cutting Blade